How To Use Drywall Wall Anchors
With a rubber mallet or hammer lightly tap the anchor into the wall until you get to the threads.
How to use drywall wall anchors. As you do the collars on the backside will spread out to clamp the wall tight. How to use drywall anchors to hang a picture leah from see jane drill demonstrates the easy way to hang a pictur. Use a pilot bit to make a hole in the wall roughly the same width as the end of the plastic anchor. Tap and screw hollow wall anchors into place. Use a screwdriver to get the anchor flush with the wall.
This is where you ll find out of the hole you drilled is either too big or too small. From the home maintenance fundamentals cu. Insert the tip of the anchor into the wall. Use a screwdriver to screw the anchor into the wall until the head of the anchor is flush with the drywall. You ll hear a click once the screw is inserted far enough into the.
In any case to use an expansion anchor start by drilling a hole in the drywall that s roughly the same diameter as the anchor. Then insert your screwdriver and tighten the central screw. Use a screwdriver to twist in the screw. Set the screw to the depth you want with the same screwdriver or drill. Watch the correct installation and expansion of each.
Pound the anchor into the drywall using a hammer making sure the head is flush with the wall. Again if you opt to use a drill go slow and be careful. After that gently hammer the anchor into the wall.